Epson 410W Projector
From Longview ISD Technology Wiki
(Difference between revisions)
(→TroubleShooting) |
(→TroubleShooting) |
||
Line 25: | Line 25: | ||
# The remote may need new batteries. Replace the batteries. ''See Image 2'' | # The remote may need new batteries. Replace the batteries. ''See Image 2'' | ||
# If the Lamp and Temp buttons are both blinking red, call the Help Desk! | # If the Lamp and Temp buttons are both blinking red, call the Help Desk! | ||
- | '''Projector Will Not Power Off''' | + | [['''Projector Will Not Power Off''']] |
If you are unable to turn the projector off with the remote try the following: | If you are unable to turn the projector off with the remote try the following: |
Revision as of 17:25, 9 January 2013
Cleaning Filter
- Turn off the projector and allow it to cool down.
- The filter is located on the side of the projector that has the lamp.
- As you face the whiteboard it is on the right side of the projector.
- Slide the filter out, as shown. This allows both sides of the filter to be cleaned.
To clean the filter you can use:
- canned air (provide your own)
- blower (if available)
- small hand vacuum cleaner (if available)
- mouth – blow VERY, VERY hard!!
- DO NOT USE WATER to clean the filter!
To clean the vent Epson recommends using a small vacuum cleaner designed for computers and other office equipment. (Do this only if you can see dust & lint inside the vent after you remove the filter.)
TroubleShooting
Projector Will Not Power On
- Make sure you do not see a light on the projector power button. See Image 1
- Use a yard stick to press the power button to see if it will turn on.
- If not, the electric breaker may be thrown. Tell custodian
- The power cord may be disconnected from the back of the projector. Check it.
- The remote may need new batteries. Replace the batteries. See Image 2
- If the Lamp and Temp buttons are both blinking red, call the Help Desk!
[[Projector Will Not Power Off]]
If you are unable to turn the projector off with the remote try the following:
- Use a yard stick to press the power button.
- Call the Help Desk to remotely turn off the projector.
- If it cannot be remotely tuned off, unplug the power cord from the back of the projector.
- Plug the power cord back in.
Overheating may cause the projector to not turn off.
- Once the projector has been turned off allow it to cool down and then clean the filter.
- If it still doesn’t work correctly, turn in a tech help request.