Epson 410W Projector
From Longview ISD Technology Wiki
(Difference between revisions)
(→Cleaning Filter) |
(→Cleaning Filter) |
||
| Line 15: | Line 15: | ||
* mouth – blow VERY, VERY hard!! | * mouth – blow VERY, VERY hard!! | ||
* '''DO NOT USE WATER''' to clean the filter! | * '''DO NOT USE WATER''' to clean the filter! | ||
| - | '''To clean the vent''' Epson recommends using a small vacuum cleaner designed for computers and other office equipment. ''(Do this only if you can see dust & lint inside the vent after you remove the filter)'' | + | '''To clean the vent''' Epson recommends using a small vacuum cleaner designed for computers and other office equipment. ''(Do this only if you can see dust & lint inside the vent after you remove the filter.)'' |
== TroubleShooting == | == TroubleShooting == | ||
Revision as of 15:57, 9 January 2013
Cleaning Filter
- Turn off the projector and allow it to cool down.
- The filter is located on the side of the projector that has the lamp.
- As you face the whiteboard it is on the right side of the projector.
- Slide the filter out, as shown. This allows both sides of the filter to be cleaned.
To clean the filter you can use:
- canned air (provide your own)
- blower (if available)
- small hand vacuum cleaner (if available)
- mouth – blow VERY, VERY hard!!
- DO NOT USE WATER to clean the filter!
To clean the vent Epson recommends using a small vacuum cleaner designed for computers and other office equipment. (Do this only if you can see dust & lint inside the vent after you remove the filter.)
