Epson 410W Projector
From Longview ISD Technology Wiki
(Difference between revisions)
(→Cleaning Filter) |
(→Cleaning Filter) |
||
| Line 13: | Line 13: | ||
#* small hand vacuum cleaner (if available) | #* small hand vacuum cleaner (if available) | ||
#* mouth – blow VERY, VERY hard!! | #* mouth – blow VERY, VERY hard!! | ||
| - | + | '''Do NOT USE WATER!''' | |
# To clean the vent (only if you can see dust & lint inside the vent after you remove the filter) | # To clean the vent (only if you can see dust & lint inside the vent after you remove the filter) | ||
Epson recommends using a small vacuum cleaner designed for computers and other office equipment. | Epson recommends using a small vacuum cleaner designed for computers and other office equipment. | ||
== TroubleShooting == | == TroubleShooting == | ||
Revision as of 15:45, 9 January 2013
Cleaning Filter
- Turn off the projector and allow it to cool down.
- The filter is located on the side of the projector that has the lamp.
- As you face the whiteboard it is on the right side of the projector.
- Slide the filter out, as shown. This allows both sides of the filter to be cleaned.
- To clean the filter you can use:
- canned air (provide your own)
- blower (if available)
- small hand vacuum cleaner (if available)
- mouth – blow VERY, VERY hard!!
Do NOT USE WATER!
- To clean the vent (only if you can see dust & lint inside the vent after you remove the filter)
Epson recommends using a small vacuum cleaner designed for computers and other office equipment.
